Import Bike Services
So you have an import bike and you are having a hard time finding a place to work on it. Or worse, you have an old import bike and nobody will touch it. Not at Rage Racing! I’ll do everything I can to get that old bike running down the road again. Need those old carburetors cleaned and synchronized? I can do it! How about getting the engine rebuilt? I can do it! Broken transmission? I can fix it. Why buy a new motorcycle when your old ride just needs a bit of work?
Do you have the need for insane speeds? Do you love the top end rush of 10,000 RPMs screaming down the road? Look no further. Though admittedly not an expert in all the import bikes out there, I have done some freakish things with more than a few of them. Does a big bore kit sound tempting? How about a stroker crank, or big cams, and tire shredding performance for the street or strip? Then give me a call and I’ll see what I can give you to satisfy your hunger to travel at the speed of light! Worried that you can’t add performance parts to your fuel-injected bike? Rage Racing can install and tune a Power Commander fuel injection computer that will wake up the sleeping giant in your ride.
Do you do your own work? I sell parts as well. I am an authorized dealer for Parts Unlimited™, Kuryakyn™, MTC engineering™, and I can get factory parts from Honda™, Suzuki™, Yamaha™, and Kawasaki™.
So, whether you have a lumbering Gold Wing that needs a little maintenance or a rust bucket sitting in the back of the garage, or even a blazing inferno of speed and performance, stop by for your next build or just your next oil change. Rage Racing will keep your ride on the road and ahead of the competition. After all, if it doesn’t frighten you, it's not fast enough.
Accessories
Big Bore Kits
Cams
Carb Rebuilds
Carb Tuning
Chroming
Diagnostics
Electrical
Full Maintenance
Ignitions
Oil
Parts
Performance Engine Builds
Stroker Kits
Suspensions
Tires
Tuning
Wheel Lacing
Wheel Truing
Here is the cost of some common work. Note that this is for comparison only. Each bike is different and the cost will vary from model to model. These are only estimates.
The shop labor rate is $60 per hour.
Oil change:
Labor: $20 / Parts: $40
Synthetic oil change:
Labor: $20 / Parts: $60
Mount and balance either front OR rear tire:
Labor: $60 / Parts: cost of tire??
Mount and balance tire already off bike up to 160mm:
Labor: $15-$20
Mount and balance tire already off bike 160+mm or radial design:
Labor: $20-$30
Install and tune power commander:
Labor: $60-$100 / Parts: $400
Install pipes:
Labor: $90 - $150
Clean, rebuild, and sync most 2 cylinder carbs:
Labor: $150 / Parts: $50
Clean, rebuild, and sync most 4 cylinder carbs:
Labor: $210 / Parts: $100
www.mtcengineering.com
www.parts-unlimited.com
www.kuryakyn.com
www.spectro-oils.com
